If you’ve ever owned a Kenwood car stereo, then you know that it can be a bit confusing to reset the unit if something goes wrong. Fortunately, there are a few simple steps that you can follow to get your stereo up and running again. In this blog post, we’ll walk you through the process of resetting your Kenwood car stereo. So, if you’re having problems with your unit, be sure to read on for help.
First step
First, you’ll need to locate the reset button on your Kenwood car stereo. This button is usually located in the faceplate of the unit. Once you’ve found the reset button, press and hold it for approximately five seconds. After a few seconds have passed, you should see the display on your Kenwood car stereo change. At this point, you can release the reset button.
Second Step
Next, you’ll need to enter the code that came with your Kenwood car stereo into the unit. The code is typically four digits long and can be found in the owner’s manual for your stereo. Once you’ve entered the code, press the “enter” or “OK” button.
Now, your Kenwood car stereo should be reset and ready to use. If you’re still having problems, be sure to consult the owner’s manual for your stereo or contact a Kenwood representative for assistance.
When To Reset Your Car Stereo?
If you are experiencing any of the following issues, it may be necessary to reset your Kenwood car stereo:
- The unit is not powering on
- Buttons are not responding
- Display is frozen or unresponsive
- Audio is distorted or not working properly
How To Reset Your Kenwood Car Stereo?
There are two ways that you can reset your Kenwood car stereo:
- Use the reset button: This method is recommended if your unit is not responding to button presses or if the display is frozen. To reset your Kenwood car stereo using the reset button, simply press and hold the “Reset” button for 3 seconds. After a few moments, your unit should power off and then power back on.
- Disconnect the power: If the reset button does not work, you can try disconnecting the power to your unit. To do this, simply unplug the power cable from your Kenwood car stereo or remove the battery if your unit is battery-powered. After a few moments, reconnect the power and turn on your Kenwood car stereo.
FAQ
How to reset Kenwood Excelon radio?
The process for resetting a Kenwood Excelon car stereo is the same as resetting any other Kenwood car stereo. Simply press and hold the “Reset” button for 3 seconds or disconnect the power to your unit.
Kenwood Miswiring error reset
If you are getting a “Miswiring” error on your Kenwood car stereo, it means that there is an issue with the wiring in your vehicle. To fix this problem, you will need to disconnect the power to your unit and then reconnect the wires according to the diagram in your Kenwood’s manual.
Why won’t my Kenwood radio turn on?
There are a few possible reasons why your Kenwood car stereo will not turn on:
- The power cable is not properly connected
- The fuse has blown
- There is an issue with the wiring in your vehicle
- The reset button needs to be pressed
If you have checked all of these things and your Kenwood car stereo still will not turn on,
Conclusion
If you’re having trouble with your Kenwood car stereo, resetting it may be the solution. In this article, we’ve shown you how to locate the reset button on your stereo and enter the code that came with it. We hope this information was helpful and that your Kenwood car stereo is now working properly. Still have questions? Let us know in the comments section below.